Safer and Stronger
This Spreader bar and integral webbing is of a unique design with two independent suspension webbing supports.
This means that in the event of a karabiner failure at one of the two harness connections the other side would be secure. Other designs are poor in that a loading of this type might load webbing in peeling and thus this mode of failure could be catastrophic.
Another unique design is that the webbing is not screwed or riveted to the aluminium spreader. Normally rivets or screws are used to fasten the webbing to the spreader immediately compromising the integrity of the main hang loops. These are also often a source of damage and wear to the webbing.
These two design features make this spreader set up safer and stronger.
In addition the aluminium spreader has no cut-outs thus making the use of lighter thinner tubing possible. This spreader is stronger and lighter. than most. The smaller diameter tube is also likely to cause less aerodynamic drag.
What length should I use?
How do I do a hang check? When flying seated under the speed bar it is far more difficult if not impossible to do a hang check on the hill side.
It is for this reason that it is extra important to standardise your flying kit. The World standard for supine flying is a hang height distance of 115cm from a tight hang loop to the top of your speed bar.
Make sure that your hang glider is set up exactly like this. Then choose your spreader bar to give you comfortable clearance under the bar when flying.
When pilots inevitably change gliders to test others this standard set up makes everything far easier and safer.
Avian can supply both hang loops and spreader bar and suspension loops if required.
This product is supplied with a single karabiner for connection to the hang glider. The karabiner is a steel screw gate design of the highest quality that we are able to purchase. It is made in Wales UK.